2004 International UDR 1500 Range III Mobile Drill Rig
- Item No
- 15008
- Condition
- Rebuilt
- Manufacturer
- International
- Status
- Available
- Model Year
- 0
- Model No
- UDR 1500 Range III Drill Rig
- Quantity
- 1
- Price
- Description
-
-
- 2004 International UDR 1500 Range III Mobile Drill Rig
- Mounted on a 2004 International 5600i Tri-Axle Truck
- Engine Hours: 11,804
- 75’- 90,000 lb static hook load capacity
- Note: Was set up for deep wireline coring, mud drilling, wireline cable of holding 6500 ft 3/8 wire rope.
- hydraulic raise and lower mast
- Rexroth 44,000 lb draw works
- Top drive
- CAT C15 14.6L diesel engine
- 525 Adv horsepower
- Engine brake
- Eaton Fuller 18 speed manual transmission
- 352” wheel base
- 40,000 lb front axle
- 51,000 lb rears
- MATCO Sub Structure - cost extra if wanted
- Note: Rig was almost completely overhauled with the Hydraulics, hoses, box, etc.
- Note on 2/3/2022: No Mud Pump currently included but have available and can supply a rebuilt Gardner Denver 5-1/2 x 8, a Gardner Denver 5 x 6, or a hydraulic drive 4’’ x 3’’ x 13 centrifugal pumps or a portable D375 duplex Emsco mud pump in good shape skid unit. Rig is in shop replacing swivel and will be going out shortly on a 3 month job (unless it is purchased before then).
- 23 to 24 ft stroke
- Code 61 Rineer/Siemen Hydraulic motor's USA with High/low torque - Estimate
- 170 RPM plus
- Substructure, Hydraulic's hook up to drill to operate sub hydraulic.
- Everything is included, handrail's, flip over wings etc etc .
- Casing size up to 16 inch for change out table bushings it also has addition scope out table, never used. Probably with minimum changes to ID of bottom bushings pins it could run 24 inch casing.
- Great shallow gas rig. Rigs last project was for a gas well company so it had to be 100% safe, daily / yearly inspections, hydraulic hoses had to removed yearly and pressure tested or replaced if damaged, zero oil leaks etc.
- Located in Canada
