Rebuilt - 6,250 / 4,650 ft/lbs of Torque (2 speed 134/180 RPM) AC Spur Power Head
26,500 lbs of Pullback
18,000 lbs main winch & 2,000 lbs sandreel
Mounted on a International 5600i Truck
CAT C-15 Diesel Engine @ 475 HP
10 Speed Transmisson
Miles 56,301
17,400 Frame Hours
Located in Northern Region, USA
Repairs completed in 2015: Install new rear carrier springs Clean cab interior Repair driver seat Install new batteries, cleaned cables and clamps Replace engine coolant hose Replace Power steering hose Repair drill table Repair drill table holding fork box Repair rear driller and helper platforms Install new feed system wire rope with thimbles and clips . Install new feed system sheave pins and bushings Repair lower sheave guards Repair DHD lubricator with new access door Repair water injection add new drive coupler guard Remove rusted tool box (small) under rod box replace with open basket Repair tower retract linkage Rebuild carousel speed reducer Repair air leaks Replace operator foot pedals , straighten table breakout wrench pivot pin Repair change over box in cab Replace rotation pump control cable Install new RH two speed wiring Install new council oil pressure gauge Disassemble compressor air cleaner to clean (filter OK) Replaced control panel controls weather boots Replace control panel winch pilot control Straightened upper breakout wrench and rain cap New Tires & Rig has DOT inspection sticker as of May 2015 Replace transmission speed shiftier control Adjusted transmission clutch Tail lights and wiring installed on rear platforms Marker lights repaired New windshield